How To Prepare Your Water Pipe To Smoke
Screw your trunk pipe until it touches the plastic ring in the trunk.
Fill the glass base of the water pipe with cold water. 8-10 pieces of ice can be added in to the water.
Screw your trunk to glass base until the base contacts the ring, in the trunk.
Make sure that the tube from the trunk pipe should be immersed into the water 1-2 cm. If the water level is not proper, arrange the level of water accordingly.
Attach the hose to the trunk and make sure that the joint is alright.
Test that your setup is airtight by placing your hand on top of the water pipe and then sucking in through the hose. There should not come any air through. If any bubbles are formed in the water, it means that air comes through, in this case check the rings of both trunk and pipe and glass base which located inside the trunk and if it is necessary you should screw them a bit more without forcing.
Put some of the tobacco into the Ceramic Tobacco Bowl crumbling into the small pieces. The level of tobacco should not exceed over the border of the Ceramic Tobacco Bowl.
Cover the tobacco bowl with the aluminum foil which is to be as big as to wrap the border. Then; stroke the aluminum foil around to supply airtight. (It is recommended to use thick foil.
The foil should be pierced as shown in the picture with your tong’s string or something sharp.
Place of the tobacco bowl on the top of the trunk with the bowl seal to joint airtight.
Now light your charcoal of your water pipe. After your charcoal is burned, turn off your oven and let it wait 3-5 minutes until the surface of it gets white and locate them on the tobacco bowl as shown in the picture with tong. At starts put just three pieces. After they get smaller and die down, you put two pieces to go on.
After 4-5 minutes lighting the charcoal on the bowl, you can start smoking. It may take 10-15 minutes to reach the top level of satisfaction (yield).
